Monitor Connections; Rack Mounting - Interlogix TruVision DVR 12HD User Manual

Description
10. One audio output
11. 10/100/1000 RJ-45
network interface
12. One RS-485 port
13. 12 VDC PSU connector Connect a PSU.
14. Power switch
15. Ground

Monitor connections

Connect a monitor to one of the recorder's outputs (BNC/VGA/HDMI). The recorder
provides a 1 Vp-p CVBS signal. See Figure 1 on page 9 for connecting a monitor to a
recorder.
The recorder supports up to 1280 × 1024 / 60 Hz resolution in VGA/HDMI. The monitor
resolution should be at least 800 × 600. Adjust your monitor accordingly to this
resolution.

Rack mounting

TVR 1204cHD is 1U & non rack mountable. TVR 1208/16HD is 1.5U and is rack
mountable using the rack mount ears delivered with the product. See Figure 2 below.
TruVision DVR 12HD User Manual
Use
Connect to speakers for audio
output.
Connect to a network.
Connect a RS-485 device such as a
PTZ camera or a keypad.
Turn the recorder on/off.
Connect to ground.
Chapter 2: Physical installation
Specification
RCA jack, 315mV, 600 ohms.
Unbalanced.
Line-level audio requires
amplification.
D+: Connect to the RS-485 A
connection on the dome camera or
keypad.
D-: Connect to the RS-485 B
connection on the dome camera or
keypad.
Each PTZ camera must be set up
individually. For information on
configuring PTZ dome camera
settings, see "Configure PTZ
settings" on page 71.
The PSU is shipped with the
recorder.
11