Table of Contents
Advertisement
lets you select which camera (or cameras) is not displayed on the local monitor unless
the user is logged in and has permission to view the camera images. A restricted
access camera is not displayed on screen when no user is logged in. Instead a person
walking by sees a black screen. See Figure 21 below.
Figure 21: Example of a restricted access camera image
To set up a camera for a restricted access view:
1. From the menu toolbar, click
2. Check which analog camera or cameras you want to have restricted access and
click Apply.
3. Click
Exit
to return to live view.
Configure PTZ settings
Use the
PTZ Setup
camera must be set up individually. The cameras must be configured before they can
be used.
Ensure that the PTZ dome cameras are correctly connected to the RS-485 port on the
back panel.
Note:
If a camera does not work correctly after configuring the recorder, check the
parameters entered.
To configure PTZ dome camera settings:
1. Click the
PTZ Control
– Or –
From the menu toolbar, click
2. Select the camera, baud rate, data bit, stop bit, parity, flow control, PTZ protocol and
address for the camera. See Appendix H "Default menu settings" on page 155 for
the default values.
TruVision DVR 12HD User Manual
Camera Setup
menu to configure only analog PTZ dome cameras. Each analog
icon on the live view toolbar.
Camera Setup
>
Restricted Access
>
PTZ
Setup.
Chapter 10: Camera setup
Camera.
71
Advertisement
Table of Contents
