Toshiba E-Studio 2500C Manual page 136

7 TopAccess Administrator Mode
5) Obtain a WINS Server Address automatically
Select "Enable" when you want to obtain a primary or secondary WINS server address auto-
matically using the DHCP server. This setting will apply only when "No AutoIP" or "Dynamic"
is selected in the Address Mode option.
When the DHCP server does not have a primary and secondary WINS server addresses, the
blank data is set to in the primary and secondary WINS server addresses even if you set the
correct primary and secondary WINS server addresses manually in the SMB Session. In
that case, select "Disable" here and set the correct primary and secondary WINS server
address in the SMB Session.
P.144 "Setting up the SMB Session"
6) Obtain a SMTP Server Address automatically
Select "Enable" when you want to obtain a SMTP server address automatically using the
DHCP server. This setting will apply only when "No AutoIP" or "Dynamic" is selected in the
Address Mode option.
When the DHCP server does not have a SMTP server address, the blank data is set to in the
SMTP server address even if you set the correct SMTP server address manually in the
SMTP Client. In that case, select "Disable" here and set the correct SMTP server address in
the SMTP Client.
P.149 "Setting up the SMTP Client"
7) Obtain a POP3 Server Address automatically
Select "Enable" when you want to obtain a POP3 server address automatically using the
DHCP server. This setting will apply only when "No AutoIP" or "Dynamic" is selected in the
Address Mode option.
When the DHCP server does not have a POP3 server address, the blank data is set to in the
POP3 server address even if you set the correct POP3 server address manually in the POP3
Network Service. In that case, select "Disable" here and set the correct POP3 server
address in the POP3 Network Service.
P.152 "Setting up the POP3 Network Service"
8) Obtain a SNTP Server Address automatically
Select "Enable" when you want to obtain a SNTP server address automatically using the
DHCP server. This setting will apply only when "No AutoIP" or "Dynamic" is selected in the
Address Mode option.
When the DHCP server does not have a SNTP server address, the blank data is set to in the
SNTP server address even if you set the correct SNTP server address manually in the SNTP
Network Service. In that case, select "Disable" here and set the correct SNTP server
address in the SNTP Network Service.
P.156 "Setting up the SNMP Network Service"
134 Setting up from TopAccess