Cancel The Alarm Action - Panasonic WJ-HD616K Operating Instructions Manual

Event action
Start recording
Display event information on the screen
Blink the alarm indicator
Sound the buzzer
Switch to the camera channel in which an alarm occurred
Move the camera to the preset position
Send a mail that notifies of an event occurrence
Send a PS·Data command that notifies of an event occur-
rence
Output signals from the ALARM connector and the ALARM/
CONTROL connector on the rear of the recorder
File event logs
Send recorded images to an FTP server
Provide an alarm notification to a PC according to the
Panasonic alarm protocol setting

Cancel the alarm action

The recorder will take an alarm action according to the settings configured in advance when an event occurs in
the alarm mode (ALM). To cancel the alarm action, press the [ALARM RESET] button on the front panel or click
the alarm icon on the status bar displayed on monitor 2.
When the "Alarm auto reset" setting on the "Common" tab under "Event" of the setup menu is set to "2s", "5s",
"10s", "20s", "30s", "1min", "3min" or "5min" (☞ Installation Guide), the following actions will automatically be
taken without canceling the alarm action by pressing the [ALARM RESET] button.
• The alarm indicator on the front panel will stop blinking and light steadily.
• The event information displayed on the monitor will disappear.
• The sounding buzzer and the alarm output will stop.
• The camera where the alarm had occurred will return to the previous status.
Step 1
Press the [ALARM RESET] button on the front panel
or click the [ALM] icon on the status bar displayed on
monitor 2.
→ The alarm action will be canceled and the alarm
indicator will go off.
Note:
• When the alarm action is canceled, the event
recording will stop and return to the operational
status just before the event occurred.
Alarm mode Activity detection mode
b
b
b
b
b
b
b
b
b
b
b
b
Off
b
X
X X
X X
X X
X X
b
X
X X
X X
X X
b b
X X
X X
57