Appendix E Firewall Cli Commands - ZyXEL Communications ZyWALL 10 User Manual

The following table describes the syntax used to configure your firewall using Command Line Interface
(CLI) commands. Select option 24.8 Command Interpreter Mode from the Main Menu to go into CLI
mode. For details on other CLI commands to configure your ZyWALL, please consult the supporting CD.
Function
F F i i r r e e w w a a l l l l
S S e e t t - - U U p p
config edit firewall active <yes
| no>
config retrieve firewall
config save firewall
D i s p l a y
D i s p l a y
config display firewall
config display firewall set <set
#>
config display firewall set <set
#> rule <rule #>
config display firewall attack
config display firewall e-mail
config display firewall ?
E E d d i i t t
E - m a i l
E - m a i l
config edit firewall e-mail mail-
server
<ip address of mail server>
config edit firewall e-mail
return-addr
<e-mail address>
CLI Commands
CLI Syntax
ZyWALL 10 Internet Security Gateway
Firewall CLI Commands
Activates or deactivates the saved firewall settings
Retrieves currently saved firewall settings
Saves the current firewall settings
Displays the all the firewall settings including e-mail, attack,
and sets/rules
Displays current entries of a set configuration; including
timeout values, name, default-permit, and number of rules
under it
If you don't put # after set, it will display all the sets/rules
information.
Displays current entries of a rule in a set configuration;
Displays all the settings for attack alert
Displays all the setting for e-mail part
Displays all the available sub commands
Edits the mail server which alerting e-mail messages are
sent through
Edits the source address for sending mail usage
Appendix E
Description
G