Chapter 12 Telnet Configuration And Capabilities; About Telnet Configuration; Telnet Under Nat; Telnet Capabilities - ZyXEL Communications ZyWALL 10 User Manual

ZyWALL 10 Internet Security Gateway
Chapter 12
Telnet Configuration and Capabilities
This chapter covers the Telnet Configuration and Capabilities of the ZyWALL.

12.1 About Telnet Configuration

Before the ZyWALL is properly setup for TCP/IP, the only option for configuring it is through the console
port. Once your ZyWALL is configured, you can use telnet to configure it remotely as shown below.

Figure 12-1 Telnet Configuration on a TCP/IP Network

12.2 Telnet Under NAT

When Network Address Translation (NAT) is enabled and an inside server is specified, telnet connections
from the outside will be forwarded to the inside server. So to configure the ZyWALL via telnet from the
outside, you must first telnet to the inside server, and then telnet from the server to the ZyWALL using its
inside LAN IP address. If no inside server is specified, telnetting to the NAT's IP address will connect to
the ZyWALL directly.

12.3 Telnet Capabilities

12.3.1 Single Administrator

To prevent confusion and discrepancy on the configuration, your ZyWALL only allows one administrator
to log in at any time. Your ZyWALL also gives priority to the console port over telnet. If you have already
connected to your ZyWALL via telnet, you will be logged out if another user logs in to the ZyWALL via
the console port.
Telnet 12-1