Configure Port Mirroring - D-Link DES-3624 Series User Manual

The fields you can set are:
♦ Anchor There are either two or three listings representing
the anchor port for each of the three trunk groups available
on the Switch (the third listing will only be displayed if an
optional two-port plug-in module is being used). The anchor
port must fall within the port range and be included as a
member port.
♦ Name Enter the desired group name. In the example
pictured above the first trunk group designates a trunk
connection between a Switch on the 6
the 7 floor
th
♦ Members Select between 2 to 8 ports in the first two
entries for this field. The number of ports defined here start
from the anchor port. Thus, in the example pictured above
containing 4 ports in the first trunk, the ports in the trunk
group will include ports (anchor), 5, 6, 8, and 11. The third
entry (used for 2-port front-panel modules) has a permanent
setting of 2 ports.
♦ State Enabled, Disabled or Clear. Be careful when clearing
trunk groups as the connections will return to normal
operation and may cause signal loops.
Port Range is a read-only field which lists the possible ports in
a selected trunk.
Press APPLY to let the changes take effect.

Configure Port Mirroring

The Switch allows you to copy frames transmitted and received
on a port and redirect the copies to another port. You can
attach a monitoring device to the mirrored port, such as a
sniffer or an RMON probe, to view details about the packets
Using the Console Interface
Stackable NWay Ethernet Switch User's Guide
floor and this one on
th
77