Power Failure - D-Link DES-3624 Series User Manual

Stackable NWay Ethernet Switch User's Guide
♦ All LED indicators will momentarily blink. This blinking
of the LED indicators represents a reset of the system.
♦ The power LED indicator will blink while the Switch loads
onboard software
approximately
continuously to indicate the Switch is in a ready state.
♦ The console LED indicator will remain ON if there is a
connection at the RS-232 port, otherwise this LED
indicator is OFF.
♦ The 100M LED indicator may remain ON or OFF
depending on the transmission speed.

Power Failure

As a precaution, the Switch should be unplugged in case of
power failure. When power is resumed, plug the Switch back
in.
12
and performs
40 seconds,
a self-test.
the LED will
Unpacking and Setup
After
light