Rear Panel - D-Link DES-3624 Series User Manual

Stackable NWay Ethernet Switch User's Guide
♦ Comprehensive LED indicators display the conditions of
the Switch and status of the network. A description of
these LED indicators follows (see LED Indicators).
♦ An RS-232 DCE console port is used to diagnose the
Switch via a connection to a PC and Local Console
Management (DES-3624i and DES-3624iF only).
♦ Nineteen or 20 high performance NWay ports all operate
at 10/100 Mbps for connection to servers and hubs. All
ports can be auto-negotiated between 10Mbps or
100Mbps.
♦ A slide-in module slot (labeled Slot1) for 10/100 Mbps
Ethernet ports can accommodate the following modules:
2-port TX, 2-port FX (MT-RJ), or 1-port FX (SC).
♦ One or two MDI-II uplink jacks are supported. Port
numbers 1 and 2 on the DES-3624 and the DES-3624F
are equipped with MDI-X jacks for normal end-node
connections and MDI-II jacks for uplink connections.
Port number 1 on the DES-3624i and DES-3624iF are
equipped with an MDI-X jack for normal end-node
connection and an MDI-II jack for uplink connection.

Rear Panel

The rear panel of the DES-3624 and the DES-3624F consist of
a slot (labeled Slot2) for a Stacking input/output port and an
AC power connector. The rear panel of the DES-3624i and
DES-3624iF consist of two slots (labeled Slot2 and Slot3). Slot2
is for Stacking input/output ports Sio1, Sio2, and Sio3. Slot3
is for an optional Gigabit Ethernet uplink (MDI-II) port. The
following shows the rear panel of the Switches.
14 Identifying External Components