User Program Mode - NAPCO XP-400 Installation Instructions Manual

Full Setting the System with Automatic
Bypassing - Home/Away with Delay
Zones
From the Keypad
Press to return protection to
C B
Home/Away with Delay Zones that have
been automatically bypassed.
minutes are allowed to walk through Exit/
Entry and Exit/Entry Follower Zones.
Using A Keyfob (GEM-KF)
All zones in the system can be armed
regardless of the state of the Exit/Entry
Zone when arming with a Keyfob and using
an AUX key programmed as Full Set. Press
and press and hold the
K
keys for 1.5s when leaving the premises. All
zones, including Home/Away Zones are
armed.
Bypassing a zone
Press the key, then the zone number to be
C
bypassed. While the panel is DISARMED, the
bypassed zone LED will flash slowly; indicating
the zone has been bypassed. While the panel is
ARMED, the bypassed zones will only be
displayed if the Display Bypassed [21-3] option
has been selected.
Unbypassing a zone (Disarmed only)
Press the
Three
zone to be unbypassed.
Group Bypass
Press
C C
Follower Zones [02] or Home/Away Zones
[01] (only if the system is programmed
exclusively for Home/Away with Delay
zones).
or
M N
Using A Keyfob (GEM-KF)
Hold the
M
Bypass all Exit/Entry Follower Zones [02] or
Home/Away Zones [01] (only if the system is
programmed exclusively for Home/Away
with Delay zones).
key then the number of the
C
to Bypass all Exit/Entry
or key on the Keyfob to
N

User Program Mode

To prevent the loss of the User 1 Code, the
panel default program includes User 1 Code
Lockout [96-2].
To change the User 1 Code from its default
value of 1234, program the 4-digit User 1 Code
through Dealer Programming [95]. User 1 Arm/
Disarm code is also used to program User
Codes 2 - 4. By default, the User 1 code cannot
be re-programmed by the user.
If it is necessary to change the User 1 code, it
can be changed through downloading or Dealer
keypad programming. From Dealer Program
Mode, change the User 1 Code Lockout ([96-2]
LED=OFF) to disabled.
Entering User Program Mode
1. Enter
A 8
2. Enter User 1 Code
( )
1 2 3 4
(Default)
9