Configuring Smartsystems Settings; Configuring Your Printer With Printset - Intermec PM4i User Manual

Configuring Your Printer With PrintSet

PM4i Mid-Range Printer User's Manual
Understanding the 802.1x Settings (continued)
Setting
Server Certificate
Validation (TTLS
and PEAP only)

Configuring SmartSystems Settings

Use the SmartSystems page to view or change the SmartSystems
server IP address and the master port number.
To configure the SmartSystems settings
1 Click Network Admin > SmartSystems.
2 View or change the settings.
3 Click Submit SmartSystems settings.
Note: You cannot communicate with the printer using PrintSet
through a USB connection. To use PrintSet, you must be connected
serially or through the Ethernet or 802.11 network.
PrintSet is a printer configuration tool that allows you to easily
change your setup parameters. You can also use PrintSet's setup
wizards to guide you through common configuration tasks.
To configure the printer with PrintSet
1 Make sure that you have a PC running Microsoft Windows 2000
or later.
2 Download PrintSet from the downloads page for the PM4i on the
Intermec website at www.intermec.com.
3 Connect your printer to your PC using a serial cable. For help, see
"Connecting the Printer to a PC Through the Serial Port" on
page 42.
Chapter 3 — Configuring the Printer
Description
Enables certificate validation. Specifies whether or not
to check if the installed CA certificate is the root of the
server certificate.
77