Expand Your Telephone System; Add And Register Handsets; To Register A Cordless Handset To Your Telephone Base - AT&T SynJ SB67158 User Manual

Getting started

Expand your telephone system

Your telephone can support a maximum of 10 handsets/desksets, or 9 handsets/
desksets and one cordless headset. You can add handsets, desksets, and one
headset (AT&T models SynJ SB67108, SynJ SB67148 and TL7600, sold separately)
to the SynJ SB67158 at any time, but each new handset/deskset or headset must
be registered to the telephone base before use. You must register each handset,
deskset and headset separately.

Add and register handsets

Additional handsets are assigned numbers in the order they are registered
(Handset 1 to Handset 10).
If the handset does not have enough power to proceed with
the registration, you need to charge the new handset for at
least five minutes (see Battery installation and charging in
the SynJ SB67108 cordless handset manual). Start registration
when the handset screen shows Press MENU on BS, sel
Registration & sel Register HS. Then put HS in cradle.

To register a cordless handset to your telephone base

1. Make sure the handset is out of the charger and the
screen shows Press MENU on BS, sel Registration &
sel Register HS. Then put HS in cradle. before you
begin registration.
2. On the telephone base, press MENU
3. Scroll down to Registration and press
ENTER again to select Register HS. The
4. Press
MENU/
telephone base screen shows Registering new device...
5. Place the unregistered handset into the charger. The
handset beeps once and begins registering to the
telephone base. It takes up to 60 seconds to complete
the registration. There is a beep sound when the
registration is successful. The telephone base shows
Handset registered and then the handset shows
X:Handset X (X represents the handset number [1-0];
Handset X represents the handset name).
NOTES:
1. If the registration is not successful, the telephone base screen displays
Registration failed with an error tone. To reset the handset, remove the
handset from the cradle. Try the registration process again.
2. Make sure to remove all unregistered system handsets or cordless
headset from the cradles before registering a new handset.
/ENTER.
ENTER.
MENU/
10
Press MENU on BS,
sel Registration
& sel Register
HS. Then put HS
in cradle.
SB67158:
COVM
Speed dial setup
Customer support
Registration
>
Register HS
>
Deregistration
Registering
new device...
Handset
registered
SB67108:
2:Handset 2
Set date & time
Charging