Telephone Base And Charger Installation - AT&T SL82118 Quick Start Manual

Getting started
Telephone base & charger installation
Install the telephone base as shown below. Make sure that the electrical outlet
is not controlled by a wall switch.
If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL)
through your telephone lines, you must have a DSL filter between the telephone
base and the telephone wall jack. The filter will prevent noise and caller ID
problems caused by DSL interference. Please contact your DSL service provider
for more information about DSL filters.
The telephone base comes with the mounting bracket installed for desktop use.
Also, the telephone line cord and the power adapter are already plugged into
the telephone base. If you want to change to wall mounting installation, see the
Mounting bracket procedure section in the user's manual for details.
Telephone base installation
2. Plug the power
adapter into an outlet
not controlled by a
wall switch.
1. Plug the other end
of the telephone line
cord into a telephone
jack.
Telephone
line cord
. Make sure the
telephone line cord
DSL filter (not included), and power adapter
required if you have cord are routed
DSL high-speed Internet through the slots on
service. the bracket.
4. Raise the antenna.