G71Mpp Or Slp98 Furnace Setting Adjustment; Replacement Icomfort ® Controls - Lennox iComfort Wi-Fi Setup Manual

G71MPP OR SLP98 FURNACE SETTING ADJUSTMENT

®
If your iComfort Wi-Fi thermostat is being used with either a G71MPP or SLP98 furnace and is set to variable-capacity mode
of operation (the iComfort
enabled in the thermostat). The stage timer will be used on the cooling side for other cooling units except the XC/XP25 where
they are not used. The furnace software sets and controls the firing rates. The only other controlling factor is the stage
temperature differentials. In Load-Tracking Variable Capacity (default for these furnaces), both stage timers and temperature
differentials are ignored.
Replacement iComfort
These kits have been set up for replacement of the iComfort
iComfort
G71MPP (rev. 03 or later)
SLP98 (rev. 01 or later)
SL280 (rev. 02 or later)
EL296 (rev. 01 or later)
CBX40UHV (rev. 02 or later) AND CBX32MV (rev. 06 or
later)
XC17
XP17 and XP17N
XP19 (rev. 06 or later)
XC21 (rev. 04 or later)
XP21 and XP21N
XP25
XC25
®
iComfort Wi-Fi
®
default with these units), the thermostat's settings for stage timers are ignored (even if shown
®
Controls
Table 18. Replacement Controls
®
Unit
®
controls. Please note that control kits are unit-specific.
Replacement Kit Catalog
Number
65W69
10G43
83W88
83W88
65W70
11H36
11H36
11H36
11H36
11H36
11F64
(repair part only)
11F64
(repair part only)
7-Day Programmable Communicating Thermostat
Page 83
Control Part Number
605341-01
102813-03
103130-03
103130-03
605341-02
103369-04
103369-04
103369-04
103369-04
103369-04
103686-03
103686-03