Set Up Speakers - Denon AVR-2311 Owner's Manual

Set up speakers

This section provides the setup methods of speaker systems other than the 7.1-channel system (with surround back speakers).
For the setup methods of the 7.1-channel system with surround back speakers, see "Set up speakers (Audyssey ® Auto Setup)" (vpage 6) of "Simple version".
First install and connect the speakers to this unit.
Before Auto Setup measurement, the settings shown below can be made.
• Changing the amplifier assignment (Amp Assign)
The signal output from the SURR.BACK / AMP ASSIGN speaker terminal of this unit can be switched to match your speaker environment (vpage 37 "Set up "Amp Assign"").
• Setting the channels to be used (Channel Select)
If channels that are not to be used are set in advance, measurement for the set channels is skipped, and measuring time can be reduced (vpage 38 "Set up "Channel Select"").
1
Set up
the remote control unit
n Set up the zone mode
ZONE SELECT
Press to switch the
zone mode to "MAIN".
The "MAIN" indicator lights.
Press ZONE SELECT
n Set up the operation mode
Press AMP to set the remote control
unit to amplifier operation mode.
Press AMP
Remote control operation
buttons
2
Connect the setup microphone.
When the setup microphone is
connected, the following screen is
displayed.
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ
STEP1 Preparation [1/6]
Connect the speakers
and place them accord-
ing to the recommenda-
tions in the manual.
Set the following
items if necessary.
Amp Assign
Channel Select
Auto Setup Start
ENTER Enter RETURN Cancel
Start Auto Setup
Move the cursor
(Up/Down/Left/Right)
3
Set up "Amp Assign"
Use ui to select "Amp Assign", and
then press ENTER .
AUTO SETUP
AUDYSSEY AUTO SETUP MultEQ
STEP1 Preparation [1/6]
Connect the speakers
and place them accord-
ing to the recommenda-
tions in the manual.
Set the following
items if necessary.
Amp Assign
Channel Select
Auto Setup Start
ENTER Enter RETURN Cancel
Set use of surround back ch. for your system
Confirm the setting
ENGLISH
around items indicate the settings.
4
Use to select the configuration
o p
of the connected speakers, and then
press RETURN .
Normal Set when using 7.1-channel
(Front/Center/Surround/Surround
Back/Subwoofer) speakers.
ZONE2
Set for connecting the speakers
for ZONE2 to the SURR. BACK/
AMP ASSIGN terminals.
Front Height Set for connecting the front
height speakers to the SURR.
BACK/AMP ASSIGN terminals.
Bi-Amp
Set for connecting a tweeter of
a front speaker to the SURR.
BACK/AMP ASSIGN terminals
and a woofer of the front speaker
to the FRONT terminals.
Front B
Set for connecting the second
set of front speakers to the
SURR. BACK/AMP ASSIGN
terminals.
2 Set for 2-channel direct/stereo
CH
playback. When "2CH" is set,
connect the second set of front
speakers to the SURR.BACK/
AMP ASSIGN terminals.
Return to previous menu
37