Connecting Speakers; Connecting The Speaker Cables - Denon D-T1 Owner's Manual

Cd receiver system

Hide thumbs Also See for D-T1:

Table of Contents

Contents

Connections

Connecting speakers

Here we connect the speakers in the room to this unit.

This section explains how to connect them using typical examples.

NOTE

0 Disconnect this unit's power plug from the power outlet before connecting the

speakers.

0 Connect so that the speaker cable core wires do not protrude from the speaker

terminal. The protection circuit may be activated if the core wires touch the rear

panel or if the + and - sides touch each other. "Protection circuit" (v p. 66)

0 Never touch the speaker terminals while the power cord is connected. Doing so

could result in electric shock.

0 Use speakers with an impedance of 6 – 16 Ω/ohms.

Carefully check the left (L) and right (R) channels and + and – polarities on

the speakers being connected to this unit, and be sure to connect the

channels and polarities correctly.

Peel off about 10 mm of sheathing from the tip of the

speaker cable, then twist the core wire tightly.

Front panel

Rear panel

Playback

Settings

Remote control

unit

Tips

Push the lever of the speaker terminal and insert the

speaker cable into the cable insertion slot.

Release your finger from the speaker terminal lever to

fix the speaker cable.

Index

Appendix

Table of Contents