Log Placement 600 Series - Vermont Castings KHLDV400PTSCSB Installation And Operating Instructions Manual

KHLDV Series Gas Fireplace
Burner Grate Assembly
LOG PLACEMENT — 600 SERIES
1. Hold log #1 with the key to the top and to the right side
of center and the notches on the bottom. Place the log
with the notches over the side supports of the grate, in
front of the fl ame bracket on the left and with the small
notch in the lower, right front of the log resting on the
back of the right tine of the grate.
Step 1
2. Hold log #2 with the holes for the pin in the back and
notches toward the front on the bottom. Position the log
on the pin provided on the back right corner of the grate
fi xture while placing the notch on the key provided on
the right side of log #1.
50
Step 2
3. Hold log #3 with the hole for the pin toward the back left
corner. Position the log on the pin provided on the back
left corner of the grate. Place the right end of the log in
the notch provided on the back left corner of the grate.
Place the right end of the log in the notch provided on
the top of log #2. Insure the log is seated securely.
Step 3
4. Hold log #4 with the notch on the bottom and toward the
back of the unit. Place the left end of the log on the key
provided on the top of log #3. Rest the right end of the
log on the hearth brick just to the right end of log #1.
5. Hold log #5 with the fat end of the log to the left and the
detailed face of the log to the front. Place the notch on
the bottom right end of the log onto the key provided
on the top of lot #1, the left end of the log should rest
on the hearth brick just outside the right front corner of
the burner and grate. You may need to hold log #5 in
place until you place lot #6.
FINAL INSTALLATION
20306742