Download
Share
Print this page
Vermont Castings Montpelier Homeowner's Installation And Operating Manual
  1. Manuals
  2. Brands
  3. Vermont Castings Manuals
  4. Indoor Fireplace
  5. Montpelier
  6. Homeowner's installation and operating manual

Vermont Castings Montpelier Homeowner's Installation And Operating Manual

Medium insert
Hide thumbs Also See for Montpelier:

Advertisement

Quick Links

See also: Homeowner's Installation and Operating Manual
SaFeTy NoTIce: IF ThIS applIaNce IS NoT pRopeRly INSTalleD, opeRaTeD aND MaIN-
TaINeD, a hoUSe FIRe May ReSUlT.
To ReDUce The RISk oF FIRe, Follow The INSTallaTIoN INSTRUcTIoNS. FaIlURe To
Follow INSTRUcTIoNS May ReSUlT IN pRopeRTy DaMage, boDIly INjURy oR eveN
DeaTh. coNTacT local bUIlDINg oFFIcIalS aboUT ReSTRIcTIoNS aND INSTallaTIoN
INSpecTIoN ReqUIReMeNTS IN yoUR aRea.
259-S-13-2
Do Not Discard This Manual: Retain for Future Use
Montpelier
Medium Insert
Homeowner's
Installation
and Operating
Manual
For Use in North America
30004403 1/13 Rev. 14

Advertisement

loading

Related Manuals for Vermont Castings Montpelier

Summary of Contents for Vermont Castings Montpelier

  • Page 1 Montpelier Medium Insert Homeowner’s Installation and Operating Manual For Use in North America SaFeTy NoTIce: IF ThIS applIaNce IS NoT pRopeRly INSTalleD, opeRaTeD aND MaIN- TaINeD, a hoUSe FIRe May ReSUlT. To ReDUce The RISk oF FIRe, Follow The INSTallaTIoN INSTRUcTIoNS. FaIlURe To Follow INSTRUcTIoNS May ReSUlT IN pRopeRTy DaMage, boDIly INjURy oR eveN DeaTh.

  • Page 2: Table Of Contents

    For more complete details on stove performance and specifications, please refer to Page 3. The Montpelier Medium Insert is designed, tested and listed for burning wood. Do not burn other fuels. Installation or service of the Montpelier Medium Insert should be performed only by a qualified installer, preferably NFI or WETT (Canada) certified.

  • Page 3: Specifications

    26 ” (680 mm) 14 ” (362 mm) 22 ” (564 mm) 11 ” (292 mm) 30 ” (774 mm) 17 ” (434 mm) 28 ” (730 mm) 22 ” 21 ” (565 mm) (548 mm) Fig. 1 Montpelier Medium Insert dimensions. 30004403...

  • Page 4: Installation

    While not required in most jurisdictions in the U.S., compliance of the fireplace with local building codes. Vermont Castings Group strongly recommends The Montpelier Medium Insert is not listed for instal- that a full stainless steel chimney liner be installed lation in factory-built fireplaces.
  • Page 5 All combustible materials of this type canada should be a minimum of 48” (1220 mm) from the front sur- face of the Montpelier Medium Insert. Be sure that family In canada (caN/cSa-b365-M91, Section 5), whether members are aware of this requirement as well, so they...
  • Page 6 (such as unpainted a height of 21¹⁄₂” (540 mm) 2. Though the Montpelier Medium Insert will fit into larger fireplaces, the concrete over dirt), a thermal floor protector must be decorative optional Vermont Castings Group Surround Panels will not used in front of and to the sides of the door as protec- completely cover the fireplace opening if these dimensions are exceeded.
  • Page 7 FP1095 Vermont Castings Group offers both steel and cast iron Fig. 5 Unless your fireplace and hearth are constructed over a Surround panel kits, each in two sizes. dirt floor (or unpainted concrete over dirt), you must use a floor enclosure area protector that satisfies the above requirements.
  • Page 8 Montpelier Medium Insert Installing the Montpelier Medium Insert 1. Remove or Disable the Fireplace Damper. If codes al- low, remove the damper. Many dampers can be removed Flexible Flue Liner simply by removing a cotter pin and/or a set screw.

  • Page 9: Operation

    This completes installation of your Montpelier Medium Insert. operation The Montpelier Medium Insert’s air supply is increased your Insert’s controls and what They Do when the control lever is moved to the left, and decreased All Montpelier Medium Insert controls are conveniently when moved to the right.
  • Page 10 Most installations do not require a large amount of combus- The Montpelier Medium Insert is designed to burn natural tion air, especially if adequate draft is available. Do not for wood only; do not burn fuels other than that for which it any reason attempt to increase the firing of your heater was designed.
  • Page 11 Special Tactics for cold-climate heating the stove, light them, and close the doors. This should heat The Montpelier Medium Insert is capable of producing up the chimney enough to initiate a draft. to 40,000 Btu/hour and heating an area of up to 1,500 sq.
  • Page 12 Montpelier Medium Insert is installed on an exterior wall at the end of a long house.

  • Page 13: Maintenance

    Large Locking must remove spills or stains from porcelain surfaces, make sure the fire is out and the Montpelier Medium Insert has cooled completely before cleaning. Use a kitchen ap- pliance cleaner and/or polish specifically formulated for enamel surfaces. Apply the cleaner sparingly with a soft Set Screw cloth, and buff away all traces.
  • Page 14 IMpoRTaNT NoTeS frame. If necessary, replace this with gasket obtained • from your local Vermont Castings’ authorized dealer. Do not operate the Montpelier Medium Insert if the Directions for replacing gaskets are given below. glass is damaged or broken. •...
  • Page 15 (such as kitty litter) to ule. To inspect the chimney, let the Montpelier Medium keep the interior of the stove dry. Insert cool completely. Then, using a strong light, sight •...

  • Page 16: Optional Accessories

    Montpelier Medium Insert Flex connection: Two Months: For parts and information about your insert, contact your Vermont Castings authorized dealer. For the name of the • Inspect the chimney and flue connection. Clean the dealer nearest you, contact: system if necessary.

  • Page 17: Replacement Parts

    38  54  52  51  53  52  33  Vermont Castings Group reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. Montpelier Medium Insert 4403  Montpelier parts  Ref. Description part Number Ref.
  • Page 18 41. Clip - Glass 30001715 NoTeS: Use if wire assembly is attached to firebox - Pre 2/24/11 Use if bracket is attached to firebox - Pre 2/24/11 Shell enamel parts - Montpelier Medium Insert part Name classic biscuit ebony brown...

  • Page 19: Warranty

    8. Vermont Castings Group shall have no obligation to to a Vermont Castings Authorized Dealer. enhance or update any unit once manufactured.
  • Page 20 149 Cleveland Drive • Paris, Kentucky 40361 www.vermontcastingsgroup.com...