Static Route Commands - ZyXEL Communications UAG Series User Manual

Chapter 11 Route
a route through the same gateway R1 (via gateway R2). The static routes are for you to tell the
UAG about the networks beyond the network connected to the UAG directly.
Figure 15 Example of Static Routing Topology

11.4 Static Route Commands

The following table describes the commands available for static route. You must use the
configure terminal
commands. See
Table 49 Command Summary: Static Route
COMMAND
[no] ip route {w.x.y.z} {w.x.y.z} {interface|w.x.y.z}
<0..127>
ip route replace {w.x.y.z} {w.x.y.z} {interface|w.x.y.z}
<0..127> with {w.x.y.z} {w.x.y.z} {interface|w.x.y.z}
<0..127>
show ip route-settings
[no] ip route control-virtual-server-rules activate
show ip route control-virtual-server-rules
104
command to enter the configuration mode before you can use these
Section Table 46 on page 99 for information on input values.
DESCRIPTION
Sets a static route. The no command deletes a static
route.
Changes an existing route's settings.
Displays static route information. Use show ip route
to see learned route information. See
on page 109.
Gives static routes priority over NAT virtual server
rules (1-1 SNAT). It also automatically gives policy
routes priority over NAT virtual server rules. Use the
no command to give NAT virtual server rules priority
over static routes.
Displays whether or not static routes have priority
over NAT virtual server rules (1-1 SNAT).
Section 12.2.5
UAG CLI Reference Guide