ZyXEL Communications UAG Series User Manual page 100

Chapter 11 Route
The following table describes the commands available for policy route. You must use the
configure terminal
commands.
Table 47 Command Summary: Policy Route
COMMAND
[no] bwm activate
policy {policy_number | append | insert
policy_number}
[no] auto-destination
[no] auto-disable
[no] bandwidth <1..1048576> priority
<1..1024> [maximize-bandwidth-usage]
[no] deactivate
[no] description description
[no] destination {address_object|any}
[no] dscp {any | <0..63>}
[no] dscp class {default | dscp_class} Sets a DSCP class. Use default to apply this policy route to incoming
dscp-marking <0..63>
dscp-marking class {default |
dscp_class}
no dscp-marking
100
command to enter the configuration mode before you can use these
DESCRIPTION
Globally enables bandwidth management. You must globally activate
bandwidth management to have individual policy routes policies apply
bandwidth management. The no command globally disables bandwidth
management.
Enters the policy-route sub-command mode to configure, add or insert
a policy.
When you set tunnel as the next-hop type (using the next-hop
tunnel command) for this route, you can use this command to have
the UAG use the local network of the peer router that initiated an
incoming dynamic IPSec tunnel as the destination address of the policy
instead of what you configure by using the destination command.
The no command disables the setting.
When you set interface or trunk as the next-hop type (using the
next-hop interface or next-hop trunk command) for this route,
you can use this command to have the UAG automatically disable this
policy route when the next-hop's connection is down. The no command
disables the setting.
Sets the maximum bandwidth and priority for the policy. The no
command removes bandwidth settings from the rule. You can also turn
maximize bandwidth usage on or off.
Disables the specified policy. The no command enables the specified
policy.
Sets a descriptive name for the policy. The no command removes the
name for the policy.
Sets the destination IP address the matched packets must have. The
no command resets the destination IP address to the default (any).
any means all IP addresses.
Sets a custom DSCP code point (0~63). This is the DSCP value of
incoming packets to which this policy route applies. any means all
DSCP value or no DSCP marker.
packets that are marked with DSCP value 0. Use one of the pre-
defined AF classes (including af11~af13, af21~af23, af31~af33, and
af41~af43) to apply this policy route to incoming packets that are
marked with the DSCP AF class.
The "af" entries stand for Assured Forwarding. The number following
the "af" identifies one of four classes and one of three drop
preferences. See
102 for more details.
Sets a DSCP value to have the UAG apply that DSCP value to the
route's outgoing packets.
Sets how the UAG handles the DSCP value of the outgoing packets that
match this route. Set this to default to have the UAG set the DSCP
value of the packets to 0. Set this to an "af" class (including
af11~af13, af21~af23, af31~af33, and af41~af43) which stands for
Assured Forwarding. The number following the "af" identifies one of
four classes and one of three drop preferences. See
Forwarding (AF) PHB for DiffServ on page 102
Use this command to have the UAG not modify the DSCP value of the
route's outgoing packets.
Assured Forwarding (AF) PHB for DiffServ on page
Assured
for more details.
UAG CLI Reference Guide