Installation Of An Nxd-1700Vg; Installing The Nxd-1700Vg Within A Cb-Tp17 Conduit Box - AMX NXD-1200VG Operation/Reference Manual

Drywall/sheetrock
Mounting tabs for
NXD Wall Mount panel
should be flush
with the outside
of the sheetrock
FIG. 55 Screw locations for conduit box attachment in a pre-wall installation

Installation of an NXD-1700VG

The NXD-1700VG can be installed either directly into the (optional) CB-TP17 or other solid surface environment using
the two different mounting options: drywall clips or solid surface screws. The following sections describe mounting the
touch panel directly into an installed pre-wall Conduit Box, a solid surface or drywall, and optional NXA-RK17 Rack
Mount Kit.

Installing the NXD-1700VG within a CB-TP17 Conduit Box

The conduit box must be mounted prior to continuing this section. Refer to the procedures in the Pre-wall Installation of
the CB-TP17 Conduit Box section on page 63 for detailed pre-wall installation instructions. Verify that all necessary
cables have been threaded through the knockouts on the conduit box and the connections have been tested prior to
installation of the NXD-1700VG.
1.
Remove the magnetic faceplate/bezel (A in FIG. 56) from the main NXD unit (B in FIG. 56) by gripping the
faceplate and pulling with gentle outward force.
VG Series Modero Touch Panels
Stud
Installation Procedures: 17" Panels
Inserted block bridges the gap
between the Conduit Box and
the notched beam
Knockouts should be located on
the left-side of the conduit box,
alongside the connectors
Stud fastening holes
Conduit Box can be
fastened to both
studs)
Use four #8 flat-head
Mounting Screws to secure
the NXD to the CB
Secure Beam to block
Depth depends on the
thickness of the Drywall
Notched stud
65