Installation Procedures: 17" Panels; Overview; Unpacking The Panel; Installing The Internal Components - AMX NXD-1200VG Operation/Reference Manual

Installation Procedures: 17" Panels

Overview

NXT panels are mounted onto flat (horizontal) surfaces in either a stand-alone or combo (NXT atop an NXA-BASE/B
battery base) configuration. NXD panels are installed into either a pre-wall surface (using the CB-TP17 conduit/wallbox)
or a solid surface (using either solid surface or drywall screws).

Unpacking the Panel

1.
Inspect and confirm the contents of the shipment box to verify that you have all specified parts. Refer to the
Specifications section on page 8 for more information about included accessories and other AMX equipment.
2.
Carefully remove the panel from the shipping box.
3.
Carefully peel the protective plastic cover from the LCD.
If the protective plastic LCD cover is not removed, the panel may not respond
properly to touch points on the LCD or allow proper screen calibration.

Installing the Internal Components

Installation of the internal components such as the NXA-PCI80211G Wireless card and NXA-RGB Interface card are
described in detail within the following sections:



Upgrading the Back Box with the MB-TP17 VESA Housing

Upgrading the existing back box with the new VESA Mounting Kit (FG033-50) requires 3 main processes:



The new MB-TP17 Universal VESA Mounting Box uses a standard VESA installation
pattern of 75 mm between holes. VESA mounts that conform to this pattern can be
used on the MB-TP17 Housing.

Removing the Original Modero Back Box

1.
Detach all connectors from the side of the touch panel.
2.
Remove the magnetic faceplate from the NXD-1700VG unit by gripping the faceplate and pulling outwards while
applying a small amount of pressure to remove it from the main unit.
3.
Place the LCD face-down on a soft cloth to expose the back of the panel and prevent scratching of the LCD.
DO NOT REMOVE THE PANEL SECURING SCREWS. These screws secure the
LCD to the metallic casing underneath.
4.
Unscrew the Stereo Output nut from the Stereo Output jack.
5.
Remove the I/O connector plate by using a grounded Phillips-head screwdriver to remove the two screws and slide
the I/O connector plate away from the back box housing.
6.
Remove the four pan-head Housing Screws from the rear of the NXD unit (FIG. 50). These screws secure the back
box to the internal panel casing.
VG Series Modero Touch Panels
Step 2: Install the 802.11g mini-PCI Wireless Card section on page 31.
Step 3: Install the NXA-RGB Card Component (NXT) section on page 32.
Removing the pre-existing back box and installing the new VESA back box.
Threading cables through the strain relief grommet opening in the rear plastic cover.
Finalizing the installation of the NXD (with VESA back box and cables) into the plastic cover, securing both
components, and finalizing the strain relief grommet installation.
Installation Procedures: 17" Panels
59