Installing Cat5 Suppression Ferrites - AMX NXD-1200VG Operation/Reference Manual

The following table provides the wiring information for each of the four (4) available connectors on each side of the
NXA-MTC/RGB Tabletop Cable.
Wire Table
Wire Connector 1
1 White/Orange
2 Orange/White
3 White/Green
4 Blue/White
5 White/Blue
6 Green/White
7 White/Brown
8 Brown/White

Installing CAT5 Suppression Ferrites

Before connecting the RJ-45 cables to the Modero Touch Panel, install the necessary number of CAT5 Suppression
Ferrites (FIG. 10) to the RJ-45 Audio/Video cable. These ferrites come as part of the Installation Kits mentioned in the
previous Specification table (page 21).
No tools are required for this installation.
Release the latch to
open the plastic
enclosure.
FIG. 10 Installing the CAT5 Suppression Ferrites
All 1200V-Series, VG-Series, and Table Top CV10 panels require the installation of
an appropriate number of CAT5 Suppression Ferrites when they use an RJ-45 cable
to feed an A/V signal from the breakout box.
1.
The CAT5 Suppression Ferrite is housed within a plastic enclosure (shown in FIG. 10) with a latch release on one
side. Pull to release the latch and open the enclosure.
2.
Grasp the Black RJ-45 Audio/Video cable being connected to the panel. This end of the cable is longer than the
opposing end which connects to the breakout box (6 inches vs 3 inches). Refer to FIG. 11 for more detailed
information.
3.
Insert the panel-end of the Black RJ-45 Audio/Video cable into the groove along the inside of the enclosure.
The CAT5 Suppression Ferrites MUST be installed onto the cable connected to the
Modero's Audio/Video RJ-45 connector (just behind the connector).
4.
Snap the enclosure shut with the cable inside, and you're done.
5.
Repeat this process again only when installing an additional CAT5 Suppression Ferrite (model specific).
VG Series Modero Touch Panels
Connector 2 Connector 3 Connector 4
White/Orange Red
Orange/White Black
White/Green -
Blue/White -
White/Blue -
Green/White -
White/Brown -
Brown/White -
Insert the CAT5
cable and close
the enclosure.
White/Orange
Orange/White
White/Green
Blue/White
White/Blue
Green/White
White/Brown
Brown/White
Push down on the
enclosure until it
snaps closed.
Touch Panel Accessories
23