Oki B721 Maintenance Manual page 98

Oki Data CONFIDENTIAL
Item
Admin Setup PCL CR Function CR
Setup
LF Function
Print Margin Normal
Pen Width
Adjust
Tray MP
ID# Tray
Tray1
Tray2
45487001TH Rev.1
Settings Functions
Sets performance when CR code is
CR+LF received in PCL.
CR: Carriage Return
CR+LF: Carriage Return and Line Feed
LF Sets performance when LF code is
LF+CR received in PCL.
LF: Line Feed
LF+CR: Line Feed and Carriage Return
Sets a non-printable area of paper.
1/5 inch The width of the area along the right and
1/6 inch left sides of paper (left and right of paper
1/12.5 inch laid out according to paper orientation)
paper outside the printable area
NORMAL: PCL emulation compatible,
approximately 1/4~1/4.3INCH (depending
on paper) is outside the printable area.
The option "1/12.5 inch" only be displayed
when Edge to Edge function was enabled.
On When the minimum width is specified in
Off PCL, if you draw a 1-dot line, it sometimes
looks broken.
With PEN WIDTH Adjust set to ON, when
the minimum width is specified, the line
width will be emphasized so as to look
wider than a 1-dot line.
1 Sets the # to specify the MPTray for
~ the paper feed destination command
4 (ESC&l#H) in PCL5e emulation.
~
59
1 Sets the # to specify Tray 1 for the paper
~ feed destination command (ESC&l#H) in
59 PCL5e emulation.
1 Sets the # to specify Tray 2 for the paper
~ feed destination command (ESC&l#H) in
5 PCL5e emulation. Displayed only if the
~ Tray 2 is installed.
59
Item
Admin Setup PCL Tray Tray3
Setup ID#
Tray4
XPS Digital-
Setup Signature
Discard-
Control
MC Mode
Unzip Mode
White Page
Skip
4. Maintenance menus
Settings Functions
1 Sets the # to specify Tray 3 for the paper
~ feed destination command (ESC&l#H) in
20 PCL5e emulation. Displayed only if the
~ Tray 3 is installed.
59
1 Sets the # to specify Tray 4 for the paper
~ feed destination command (ESC&l#H) in
21 PCL5e emulation. Displayed only if the
~ Tray 4 is installed.
59
Print Invalid Sign Sets up the DigitalSignature function.
PrintOnlyValidSign Print Invalid Sign: If a document has been
Off tampered, the printer prints a normal print
report and a temper error report.
Print Only Valid Sign: If a document has
been tampered, the printer prints only a
tamper error report.
Off: No signatures are verified.
Auto Sets up the DiscardControl function.
Each Page Auto: Frees resources as necessary.
Off EachPage: Frees resources page by page
according to markups.
Off: Disables the DiscardControl function.
On Sets up the MarkupComaptibility function.
Off On: Uses the MarkupComaptibility
function.
Off: Not use the MarkupComaptibility
function.
Auto Specifies the unzip method for XPS flies.
Speed Auto: Automatically switches modes
Print depending on files.
Speed: Prioritizes print speed and doesn't
use the partial Unzip function.
Print: Prioritizes print processing and uses
the partial Unzip function.
On Sets whether or not to eject pages that
Off contain no print data (blank pages) using
XPS.
When Off is selected, blank pages are
ejected, if any.
4-13 /