Oki B721 Maintenance Manual page 49

Oki Data CONFIDENTIAL
WPS-PBC
(1) Press the scroll button to select [Wireless Setting] and then press the <ENTER>
button.
(2) Enter the administrator password using the ten-key pad, then press the <ENTER>
button.
The factory default password is "aaaaaa". Press the <ENTER> button whenever
inputting one character.
(3) When the display shown below appears, read it carefully. Press the <ENTER>
button or wait until the display changes.
(4) Check that [Automatic Setup (WPS)] is selected and then press the <ENTER>
button.
45487001TH Rev.1
(5) Check that [WPS-PBC] is selected and then press the <ENTER> button.
(6) Select [Yes] and then press the <ENTER> button.
Memo If [No] is selected, the screen returns to that from step 5.
(7) When [Running pushbutton method...] is displayed, press and hold the push button
on the access point of the Wireless LAN for several seconds then release it.
Note! • [Running pushbutton method...] is displayed for about two minutes. Press
and hold the push button on the access point of the Wireless LAN while it is
displayed.
• For the position of the push button on the access point of the Wireless LAN
and how long it should be held pressed, refer to the operation manual for
the access point of the Wireless LAN.
• While [Running pushbutton method...] is displayed, the printer cannot be
operated.
• When [WPS Connection successful is displayed, this equipment is
connected to the wireless LAN.
2. Installation
2-32 /