Oki B721 Maintenance Manual page 91

Oki Data CONFIDENTIAL
Item
Menus System Timeout Network
Adjust
Low Toner
Jam Recovery
Error Report
Hex Dump
45487001TH Rev.1
Settings Functions
0 seconds Time of open of Network port after end of
5 seconds job
~ Time of the port open indicates the time
90 seconds that open the current port which receiving
~ the current job and so other port be able
290 seconds to receive data.
295 seconds It increase /decreases in the step of 5
300 seconds [Conditions for display]
A NIC FW is installed.
Continue Sets printer operation when Toner Low is
Stop
detected.
In CONTINUE, the printer can continue
printing while remaining ON-LINE.
In STOP, it becomes OFF-LINE.
[Conditions for display]
The consumable is SEPARATION mode or
COMBINATION mode will be decided by
a PU Factory PJL command. This menu
item is only displayed in the SEPARATION
mode.
On Sets whether JAM RECOVERY printing is
Off
performed or not when Jam occurs.
When it is set to OFF, a job that includes
the page to which Jam has occurred will
be cancelled.
On Sets whether an error report is printed or
Off
not when an internal error occurs.
Valid only for PS and PCL XL.
Execute Prints out data received from the host
PC in the hexadecimal Dump. Turning off
the power supply switch restores Normal
Mode from HEX Dump Mode.
Item
Menus Print Print MPtray, X
Adjust Position Adjust
Tray1,
Adjust
Tray2,
Tray3,
Tray4
Y
Adjust
Duplex
print X
Adjust
Duplex
print Y
Adjust
Paper Black Setting
Trans. Black Setting
4. Maintenance menus
Settings Functions
0.00 mm Adjusts the position of a whole print image
+0.25 mm to
in the direction that is perpendicular to the
+2.00 mm
direction paper runs, that is horizontally (at
-2.00 mm to
0.25 mm pitch).
-0.25 mm
0.00 mm Adjust the position of a whole print image
+0.25 mm to
in the direction paper runs, that is vertically
+2.00 mm
(at 0.25mm pitch).
-2.00 mm to
-0.25 mm
0.00 mm At the time of back page printing of
+0.25 mm to
Duplex, adjusts the position of the
+2.00 mm
whole print image in the direction that is
-2.00 mm to
perpendicular to the direction paper runs,
-0.25 mm
that is horizontally (at 0.25mm pitch).
0.00 mm At the time of back page printing of
+0.25 mm to
Duplex, adjusts the position of a whole
+2.00 mm
print image in the direction paper runs,
-2.00 mm to
that is vertically (at 0.25mm pitch).
-0.25 mm
0 Use it for fine adjustment of the significant
+1 dust attachment on the surface and when
+2 thin spot has the sighificant impact on the
+3 standard/BLACK printing or other cases
-3 occur. The decrement is necessary if the
-2 scattered or snow-white like printing is the
-1 result in the high density-printing area. The
increment is necessary if the thin printing
is found.
0 Use it for fine adjustment of the significant
+1 dust attachment on the surface and when
+2 thin spot has the significant impact on
+3 OHP/BLACK printing. The decrement
-3 is necessary if the scattered or snow-
-2 white like printing is the result in the high
-1 density-printing area. The increment is
necessary if the thin printing is found.
4-6 /