Factory Five Racing Mk4 Roadster Assembly Manual page 332

Press the bronze bushings into the holes in the hinge arms as shown. The short hinge arms are both the
same.
Attach the hinge arms to the arm support plate as shown using the ⅜" shoulder bolts, spacers, nylon lock
nuts and washers. The spacer fits over the bronze bushing after it is pressed into the arm holes. The
flange of the bronze bushings should contact the arm plate. Tighten the nuts and then back off until the
arms rotate easily.
If you tighten the nut tight and the arm still moves easily then back off the nut and adjust the
washer.
Drivers side long arm with bushings pressed in
Passenger side long arm with bushings pressed in
Short arm with bushings pressed in.
www.factoryfive.com
331
508-291-3443