Factory Five Racing Mk4 Roadster Assembly Manual page 329

Once you are happy with the alignment you can set the panel gap and radius the edges. An easy way to
set the gap is by using a marker. With the panel in place, run a marker around the edge of the panel so
that it tubs the body lip all of the way around. This will leave a line on the panel that may be thicker or
thinner in areas. Sand, grind or cut the panel back so the marker line can not be seen. Remount the
panel and the resulting gap should be the same around the whole panel, about / ".
3
16
328
www.factoryfive.com 508-291-3443