New Buck Corporation EMBER VISION 100 SERIES Installation Instructions Manual page 17

* If the pilot will not stay lit after several tries, turn the gas control knob to "OFF" and call
your service technician or gas supplier.
10. Turn control knob counterclockwise
11. If using unit without wall thermostat place Auto/Off/Manual switch into the manual
position. If using wall thermostat place Auto Off Manual Switch into the auto position and
place thermostat to a setting higher than the room temperature.
12. "Turn on all electrical power to the appliance."
13. Your heater is equipped with a HI & LO control. Turn clockwise for Low and
counterclockwise for High.
DO NOT TRY TO ADJUST HEATING LEVELS BY USING THE MANUAL SHUTOFF
VALVE.
SHUTTING OFF UNIT
1. "If equipped with thermostat set to lowest setting."
2. Turn control knob clockwise
3. Turn off all electric power to the appliance if service is to be performed.
SHUTTING OFF BURNER ONLY (Pilot stays lit.)
1. Turn control knob clockwise
CAUTION:
Hot while in operation. Do Not Touch. Keep children, clothing, furniture,
gasoline, and other liquids having flammable vapors away.
CAUTION:
DO NOT TRY TO ADJUST HEATING LEVELS BY USING THE
MANUAL SHUTOFF VALVE.
WARNING:
Improper installation, adjustment, alteration, service or maintenance can
cause property damage, personal injury, or loss of life. Refer to owner's information manual
provided with this appliance.
installer, service agency, or the gas supplier.
IMPORTANT:
"OFF" positions. Never use the heater at a setting between these positions as this can result in
improper combustion and excessive carbon monoxide emissions.
CAUTION
TO TURN OFF GAS TO
APPLIANCE
Installation and service must be performed by a qualified
Always operate the appliance at the completely "ON" or the completely
to "ON".
to the "OFF".
to the "PILOT" position.
Page 13