Adf Cable Removal - Lexmark X543 Service Manual

ADF cable removal

1.
Remove the simplex, or duplex ADF rear cover. See
2.
Remove the left cover.See
3.
Remove the AIO back cable cover.See
4.
Remove the rear shield. See
5.
Disconnect the ADF cable (A) from the relay card in the ADF unit.
6.
Disconnect the ground (B) from the ADF.
7.
Disconnect the ADF cable from connector JADF1 on the controller board.
8.
Disconnect the ground (C) from the print engine.
"Left cover removal" on page 4-4
"AIO back cable cover removal" on page 4-8
"Rear shield removal" on page 4-7
A
B
B
A
C
7525-xxx
4-85
Repair information