Using The Printer's Internal Web Server - Lexmark X543 Service Manual

Using the printer's internal Web server

Before updating the firmware, download the zip file containing the firmware files from http:support.lexmark.com/
printerfirmware and inputting keycode x54x (all lowercase).
Note: You will need the IP address of the printer on the network. This can be obtained from the Network
Settings page found under Network Setup menu under Reports, in the Administrative menu. You can also
navigate to Menu > Network/Ports > Network Menu > Network Setup > TCP/IP > IP Address.
Warning: Before performing a firmware update on the printer, contact the technical service center or second
level of support to verify the correct firmware and keycode. The wrong firmware or wrong level of
firmware could lead to a malfunction or render the printer inoperable.
To update the printer's firmware, perform the follow steps:
RIP firmware update
1.
POR the printer to Ready.
2.
On a computer attached to the network, open a Web browser.
3.
Enter the printers IP address in the Web browsers address bar.
4.
Press Enter. The printers homepage opens.
5.
Click Settings. The settings page opens.
6.
Click the Update Firmware link. The update firmware page opens.
7.
Click the Browse button. A file browser will open.
8.
Browse to fullnet.fls (also known as 1.fls).
Warning: fullnet.fls must be updated first. Failure to do so could render the printer inoperable.
9.
Click Open.
10.
Click Submit. Various status and progress messages will appear on the operator panel. The printer will
reboot. The webpage will post "File Transfer Complete". The HTTP session will terminate.
Warning: Do not turn the machine off until the update is complete. When the firmware update is
completed, the printer will automatically reboot and return to a Ready state.
Engine firmware update
11.
On a computer attached to the network, open a Web browser.
12.
Enter the printers IP address in the Web browsers address bar.
13.
Press Enter. The printers homepage opens.
14.
Click Settings. The settings page opens.
15.
Click the Update Firmware link. The update firmware page opens.
16.
Click the Browse button. A file browser will open.
17.
Browse to updeng.fls (also known as 2.fls).
18.
Click Open.
19.
Click Submit. Various status and progress messages will appear on the operator panel. The printer will
reboot. The webpage will post "File Transfer Complete". The HTTP session will terminate.
Warning: Do not turn the machine off until the update is complete. When the firmware update is
completed, the printer will automatically reboot and return to a Ready state.
7525-xxx
3-55
Diagnostic aids