Wiring - Furuno GP-1670 Operator's Manual

12.3

Wiring

All wiring are terminated at the rear of the display unit. Refer to the interconnection
diagram on page S-1.
Ground terminal
Power cable
Connect the power cable to the power connector. Connect the leads to the battery (12
or 24 VDC); white to plus(+) terminal and black to minus(-) terminal. Ground the shield
to ship's ground.
Cable connector
Note: The fuse is not waterproof. Wrap the fuse holder with vinyl tape to keep water
out of the fuse holder.
White
Black
Shield
Power cable
w/fuse (3A)
Lead wire
Black
BATTERY
Display unit (back)
CAN bus
connector
GPS antenna unit
GPA-017/017S
White
Shield
Ground
12. INSTALLATION
12-3