Can Bus Input And Output Data - Furuno GP-1670 Operator's Manual

12. INSTALLATION
12.4.2

CAN bus input and output data

How to select CAN bus input and output data
1. Long-press the ESC/MENU key to open the menu.
2. Rotate the RotoKey
3. Use the RotoKey
4. Select the data to input as follows:
1) Use the RotoKey
SOG/COG], [DEPTH], [WATER TEMPERATURE] and [SPEED THROUGH
WATER], the following options windows appear.
2) For [POSITION & SOG/COG]:
[Internal GPS]: Use the internal GPS navigator to fix position.
[Auto]: Select if you have multiple external navigators connected and want to
use them instead of the internal GPS. In this case, the navigator with the low-
est IP address has priority.
If you have a FURUNO external navigator speed/course source connected, its
name appears below [Auto]. Select the model name to have that device feed
corresponding data.
3) For [DEPTH], [WATER TEMPERATURE] and [SPEED THROUGH WATER],
Select [Auto] when multiple sources are available. In this case, the device with
the lowest IP address has priority.
If the external source is a FURUNO make, its name appears below [Auto]. Se-
lect the device name to have the device feed respective data.
12-8
TM
to select [INTERFACE] then push the key.
TM
to select [SELECT INPUT DEVICE] then push the key.
TM
to select a data then push the key. For [POSITION &
Name of connected
equipment appears here
POSITION & DEPTH, WATER TEMPERATURE,
SOG/COG SPEED THROUGH WATER
Auto