Paper Jam Service Check - Lexmark C78x Service Manual

200.04 paper jam service check

S2 sensor late
Note: See "Printer sensors" on page
Step Actions and questions
1 Check the tray for proper edge guide setting and media
loading. Edge guides should be adjusted against edge
of media. Media should be fanned and lay flat in the
tray.
Is the media properly loaded in the tray?
2 Check the pick tires for contamination or wear.
Are pick tires worn or contaminated?
3
Check for obstructions in the paper path.
Is the paper path obstructed?
4 Is the inner deflector out of position?
5 If the pick arm clutch and shaft are not completely
snapped together, the pick arm tires will not rotate
freely in the direction shown.
Is pick arm clutch and shaft completely snapped
together?
6 Is the autocompensator damaged or defective?
7 Perform the
the S2 sensor.
Does the S2 sensor pass the test?
5-3.
"BASE SENSOR TEST" on page 3-24
Yes
Go to step 2
Replace the pick
rolls. See "Pick
rolls removal"
on page 4-70.
Clear the
obstruction.
Correct the inner
deflector position.
Go to step 6
Go to
"Autocompensa
tor service
check" on
page 2-78.
on Contact your next
level of support.
Diagnostic information
5061
No
Properly load
media.
Go to step 3
Go to step 4
Go to step 5
Slide the clutch,
and snap it onto
the shaft.
Go to step 7
See "200.21,
200.28, and
200.29 paper
jam service
check" on
page 2-32.
2-29