U052 Setting The Fuser Motor Control - Kyocera TASKalfa 250ci Service Manual

Maintenance
item No.
Setting the fuser motor control
U052
Description
Enters the sensor data values described on the supplied sheet provided when the loop sensor is replaced and
performs correction processing for the fuser motor.
Purpose
To perform when replacing the loop sensor or paper conveying unit.
Method
1. Press the start key.
2. Select the item. The screen for executing each item is displayed.
Display
Set Loop Sensor
Loop Sensor Control
Loop Sensor Valid*
*: 25/25, 30/30 ppm model only.
Method: [Set Loop Sensor]
1. Select [Scanning Board1].
2. Enter the sensor data value of supplied sheet DATA1 using the cur-
sor +/- keys.
3. Select [Scanning Board2].
4. Enter the sensor data value of supplied sheet DATA2 using the cur-
sor +/- keys.
5. Press the start key. The value is set.
Setting: [Loop Sensor Control]
1. Select the item.
2. Select ON or OFF.
Display
Top 250mm
Top 290mm
Top 330mm
Top 370mm
3. Press the start key. The setting is set.
Setting: [Loop Sensor Valid]
1. Select ON or OFF.
Display
ON
OFF
Initial setting: OFF
2. Press the start key. The setting is set.
Completion
Press the stop key. The indication for selecting a maintenance item No. appears.
Description
Description
Enter the data value for loop sensor
Set the loop sensor detection control
Set whether to enable or disable the loop sensor
Description
Sensor detection ON/OFF setting at 250 mm from
the top of paper
Sensor detection ON/OFF setting at 290 mm from
the top of paper
Sensor detection ON/OFF setting at 330 mm from
the top of paper
Sensor detection ON/OFF setting at 370 mm from
the top of paper
Description
Loop sensor is enabled
Loop sensor is disabled
2JZ/2JX/2JV/2H7-1
How to read the sensor data value
(e.g.) 1
2
3
4
5
6
7
8
9
0
3 6 4
Initial setting
OFF
ON
ON
ON
1-3-31