U246 Setting The Paper Ejection Device - Kyocera TASKalfa 250ci Service Manual

Maintenance
item No.
Setting the paper ejection device
U246
Description
Provides various settings for the optional 3000-sheet document finisher, if furnished.
Purpose
Adjustment of registration stop timing in punch mode
Adjust if skewed paper conveying occurs or if the copy paper is Z-folded in punch mode.
Adjustment of paper stop timing in the punch mode
To adjust this item when the position of a punch hole is different from the specified one.
Adjustment of front/rear side registration home position of Inner tray
Provides optimization when paper jam occurs due to an inferior fitting of the Inner tray adjuster guides to
paper.
Adjusting of front and back/slanted stapling home position
Adjusts the stapling position in the staple mode if the position is not proper.
Provides adjustment of slanted stapling.
Adjustment of upper/lower side registration home position of center-folding unit
Provides optimization when paper jam occurs due to an inferior fitting of the centerfold adjuster guides to paper.
Adjustment of booklet stapling position
Adjusts the booklet stapling position in the stitching mode if the position is not proper.
Adjustment of center folding position
Adjusts the center folding position in the stitching mode if the position is not proper.
Method
1. Press the start key.
2. Select the item to set. The screen for setting each item is displayed.
Display
3000 FINISHER
BOOKLET FOLDER
Method: [3000 FINISHER]
1. Select the item to set. The screen for setting each item is displayed.
Display
PUNCH REG ADJ
PUNCH POSITION ADJ
WIDTH F HP ADJ
WIDTH R HP ADJ
STAPLE HP ADJ
TURNED STAPLE HP ADJ
Setting: [PUNCH REG ADJ]
1. Change the setting value using the cursor up/down keys.
Description
Adjustment of registration stop timing
If skewed paper conveying occurs (sample 1), increase the preset value. If the copy paper is Z-folded
(sample 2), decrease the preset value.
2. Press the start key. The value is set.
Description
Description
Adjustment of 3000-sheet document finisher
Adjustment of center-folding unit
Description
Adjustment of registration stop timing in punch mode
Adjustment of the paper stop timing in punch mode
Adjustment of front side registration home position
Adjustment of rear side registration home position
Adjustment of front and back stapling home position
Adjustment of slanted stapling home position
Sample 1
Figure 1-3-16
Setting Initial
range setting
-20 to 20 0
Sample 2
2JZ/2JX/2JV/2H7
Change in
value per step
1 ms
1-3-93