Assembly - Horizon Fitness 1.2T User Manual

1.2T ASSEMBLY
PR E- AS S EM BLY
WARNING
NOTE:
It is recommended that you apply grease to the threads of each bolt as you assemble your treadmill, to prevent
loosening and noise. Also, during each assembly step, ensure that ALL nuts and bolts are in place and partially
threaded in before completely tightening any ONE bolt.
A S SE MB LY S T E P 1
HARDWARE BAG 1 CONTENTS :

DO NOT CUT STRAPS UNTIL STEP 1-E!*
packaging that is not beneath the treadmill. Do not attempt to lift the treadmill at this
time. Remove plastic wrap from console masts.
Disassemble box and remove the cardboard
A
Open HARDWARE BAG 1.
B
Raise the CONSOLE MAST to the
vertical position. Be sure to hold
the console mast firmly, as it
will not stay in the upright
position on it's own.
C
Move LEFT SIDE LINKAGE ARM
into position. Insert BOLT (A)
and tighten. Slide LINK ARM
COVER over LOWER LINK ARM
joint.
D
Repeat on the right side.
E
Now cut the banding straps and
remove remaining packaging
material.*
* NOTE: If the straps have been removed
before completing step 1-D and the
linkage arms cannot be aligned,
refer to the TROUBLESHOOTING
section (page 35) in order to restore
the treadmill to its proper position.