Need Help; Pre-Assembly - Horizon Fitness EVOLVE 3.0 Owner's Manual

TABLET/READING RACK
CONTROL PANEL & DISPLAY
WINDOWS
MULTI-STORAGE AREA
PULSE GRIP HANDLEBARS
ON/OFF SWITCH
POWER CORD
MOTOR COVER
10
CONSOLE
SAFETY KEY
CONSOLE MAST
SIDE RAIL
RUNNING DECK / RUNNING BELT
ROLLER END CAP
REAR ROLLER
TENSION/ALIGNMENT BOLTS
PRE ASSEMBLY
TOOLS INCLUDED:
F
6 mm T-Wrench
F
6 mm L-Wrench
WARNING
PARTS INCLUDED:
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift
F
1 Hardware Kit
treadmill from packaging until specified to do so in the assembly
F
1 Safety Key
instructions. You may remove the plastic wrap from console masts.
F
1 Bottle of Silicone Lubricant
F UNPACKING
1 Power Cord
F
2 Covers
Place the treadmill carton on a level flat surface. It is recommended that you place
a protective covering on your floor. Take CAUTION when handling and transporting
this unit. Never open box when it is on its side. Once the banding straps have been
removed, do not lift or transport this unit unless it is fully assembled. Unpack and
assemble the unit where it will be used. The enclosed treadmill is equipped with
high-pressure shocks and may spring open if mishandled.
WARNING

NEED HELP?

FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
If you have questions or if
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
there are any missing parts,
partially threaded in before completely tightening any ONE bolt.
contact Customer
NOTE: A light application of grease may aid in the installation of hardware. Any
Tech Support.
grease, such as lithium bike grease is recommended.
11