Section 8: Installing & Removing The Door - Montigo P52DF Installation & Maintenance Manual

P52DF* Indoor Gas Fireplace
Section 8: Installing & Removing the Door
Removing the door:
The P52DF* doors are removed in a few simple steps.
Follow these below to remove the Horizontal access panel,
unlatch the door buckles and, remove the door. Replace
in reverse order.
Remove the Horizontal Access Panel:
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.
Step 1:
Remove the Horizontal Access Panel:
Remove the Horizontal
cover by placing fingers
in both finger holes, then
pushing away from you
and lifting out. Place it
aside during maintenance
or cleaning.
Install in reverse order.
Figure 22. Removing and installing the Horizontal .......
Access Panel
Step 2: Locate the Door Buckles:
Figure 22a. Locate the door buckles.
Page 22
Installation
Finger Holes
Installed Gas
Valve Cove r
Step 3: Release the Door Buckles
Hand-hold
Figure 22b. Door buckle Tool
Step 4:
Firmly grasp hand-
hold end of Door
buckle tool and place
the machined end in
the slot under door
frame. (as shown)
Figure 22c.
Step 5:
Ensure the tool is firmly
in the lower end of
the slot, (as shown),
Then pull toward you
(Caution: hold the tool
securely).
Figure 22d.
Step 6:
Pull hard if necessary
to release the spring
tension. (Caution: The
latch springs back with
force, hold the tool
securely).
Figure 22e.
Step 7:
Remove the tool from
the latch slot. Ensure
the latches are hanging
freely, the hook end
is released from the
bottom of the door.
(Repeat all 4-steps for
the remaining latches).
Figure 22f.
Door Latch Slot
Door Latch Hook
1
2
3
4
XG0196 - 150204.3