Section 7: Screen Installation And Removal - Montigo P52DF Installation & Maintenance Manual

Section 7: Screen Installation and Removal

Removing / Attaching Screens:
To Remove Screens:
Grasp each top outer corner of the screen with your
thumb and finger and pull towards yourself. When the
upper Screen Studs are free, lift the screen at an angle
from the lower slots from which the Screen Bottom
Tabs are held. Place the screen in a safe place.
To Install Screens:
Hold the screens at an angle away from the fireplace,
and locate the Screen Bottom Tabs at the lower corners
of the screen. Place the screen into the Screen Tab
Receptacles in the lower section of the fireplace.
Make sure the tabs and screens are lowered all the
way down into the Screen Tab Receptacles on the
fireplace. Then, push each Upper Screen Stud on
the top corners of the screen into the Upper Screen
Stud Receptacles in the fireplace.
Figure 21a. Screen Door Numbers (Replacement Parts)
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEATING PRODUCTS IS PROHIBITED.
XG0196 - 150204.3
Installation
Replacement Screens:
For replacement part order numbers, please refer to
section "Replacement Parts:" on page 30.
Note: Do not operate fireplace without all screens
in place.
NAME DATE Description
DIMENSIONS ARE IN INCHES
TOLERANCES:
PC
Drawn by 01/22/2015
FRACTIONAL 1/32"
TWO PLACE DECIMAL .015"
DWG. NO.
A
Revision / Date
THREE PLACE DECIMAL .005"
Revision
ALL BENDS ARE ASSUMED MATERIAL
TO BE 90 UNLESS NOTED
Finish
OTHERWISE.
SCALE
Left Side Detail
Upper Screen
Stud Catch
Left Side Detail
Screen Tab
Receptacles
Figure 21b. Screen Installation and Removal
P52DF SCREEN
P52DF-SCREEN
1:12 WEIGHT: SHEET 1 OF 1
P52DF* Indoor Gas Fireplace
Upper Screen
Studs
Screen Bottom
Tabs
Page 21
Re
Th
To R
Sim
out
wit
fin
you
Scr
an
fro
wh
Tab
scr
To I
Ho
ang
fire
Scr
low
scr
Tab
low
fire
tab
low
int
Rec
fire
Up
top
int
Stu
fire