E-2 Installing a New Battery
Installation Procedures
The battery that came with the workstation is permanently installed on the
system board. If the original battery becomes inoperative, you must install a
second battery.
To install the replacement battery:
1. If the workstation is on, turn it off, then unplug the power cord from the
2. Remove the side access panel and the expansion board assembly.
3. Remove and discard the protective covering on the adhesive on the hook
4. Plug the battery connector onto pins 1-4 on the battery header of the
Figure E-1.
WARNING: The system board contains a lithium battery. The
battery may explode if mistreated. The battery is soldered in
place and may not be removed. Do not abuse or disassemble.
Use only replacement batteries supplied by Compaq.
grounded AC outlet.
and loop fastener on the back of the battery and attach the battery to the
side of the power supply.
system board.
Attaching the replacement battery