Watermark Adjustment For Density Compensation - Oki C931 User Manual

Matching colors using the control panel
Watermark adjustment for
density compensation
1
You can adjust the watermarks for the density
based on the density compensation.
Adjust each color separately for the parts where
the density is a nuisance from the print results.
2
This section explains the procedure for adjusting
the cyan watermarks. Use the same adjustment
procedure also for other colors that you wish to
adjust.
3
z Increasing cyan after checking the print results
1
Press the [Fn] key.
The numerical values input screen will
be displayed.
4
5
2
Press [3], [1], [0], and press the [OK]
button.
Memo
z The procedures for adjusting magenta, yellow, and
black are described below.
– To adjust magenta, press the [Fn] key, [3], [1],
[1], and [OK] buttons.
– To adjust yellow, press the [Fn] key, [3], [1], [2],
and [OK] buttons.
– To adjust black, press the [Fn] key, [3], [1], [3],
and [OK] buttons.
3
Specify a larger value than the current
value, and press the [OK] button.
Memo
z To increase the density, select +1 to +3, and to
decrease the density select -1 to -3.
4
Press the [ON LINE] button to return to
the standby screen.
5
Press the [Fn] key, [3], [0], [0], and
press the [OK] button.
6
Check that [Execute] has been selected,
and press the [OK] button.
- 122 -