Dynamic Routing Screen - ZyXEL Communications LTE3301 Series User Manual

Table 43 Network > Routing > Static Route: Add/Edit
LABEL
IP Subnet Mask
Gateway IP
Address
Back
Apply
Cancel

12.3 Dynamic Routing Screen

Use this screen to enable and configure RIP on the LTE3301. Click Network > Routing >
Dynamic Routing to open the Dynamic Routing screen.
Figure 66 Network > Routing > Dynamic Routing
The following table describes the labels in this screen.
Table 44 Network > Routing > Dynamic Routing
LABEL
Dynamic Routing
Apply
Cancel
Chapter 12 Routing
DESCRIPTION
Enter the IP subnet mask here.
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the
same segment as your LTE3301's interface(s). The gateway helps forward packets to their
destinations.
Click Back to return to the previous screen without saving.
Click Apply to save your changes back to the LTE3301.
Click Cancel to set every field in this screen to its last-saved value.
DESCRIPTION
RIP (Routing Information Protocol) allows a router to exchange routing information with
other routers. The RIP version controls the format and the broadcasting method of the RIP
packets that the LTE3301 sends (it recognizes both formats when receiving). RIP version
1 is universally supported but RIP version 2 carries more information. RIP version 1 is
probably adequate for most networks, unless you have an unusual network topology.
Select the RIP version from RIPv1 and RIPv2. Otherwise, select Disable to turn if off.
Click Apply to save your changes back to the LTE3301.
Click Cancel to begin configuring this screen afresh.
LTE3301 Series User's Guide
101