ZyXEL Communications LTE3301 Series User Manual page 57

Figure 31 Network > WAN > Network Scan
The following table describes the labels in this screen.
Table 15 Network > WAN > Network Scan
LABEL DESCRIPTION
Physical Interface This shows the type of the interface used by the WAN connection.
Network Type Select the type of the network (4G only, 3G only, or 3G/4G) to which you want the
LTE3301 to connect when there is a SIM card inserted.
Scan Approach Select Auto to have the LTE3301 connect to an available network using the default
settings on the SIM card. If the currently registered mobile network is not available
or the mobile network's signal strength is too low, the LTE3301 switches to another
available mobile network.
Select Manually to search for and select the mobile network(s) to which you want
the LTE3301 to connect.
Network Provider List This table is available only when you set Scan Approach to Manually.
Click Scan to search for available mobile networks based on the network type you
selected.
Click Apply to save your changes in the Action field.
Provider Name This shows the name of the service provider.
Mobile System This shows the mobile telecommunications standard supported by the mobile
network.
Network Status This shows whether the mobile network is available.
Action Click Select to have the LTE3301 establish a connection to the selected mobile
network.
Apply Click Apply to save your changes back to the LTE3301.
Cancel Click Cancel to reload the previous configuration for this screen.
Refresh Click Refresh to update this screen.
Chapter 6 WAN
LTE3301 Series User's Guide
57