Mac Filter Screen - ZyXEL Communications LTE3301 Series User Manual

The following table describes the labels in this screen.
Table 24 Network > Wireless LAN > More AP: Edit
LABEL
Active
Name (SSID)
Hide SSID
Intra-BSS Traffic
WMM QoS
Security Mode
Apply
Cancel

7.5 MAC Filter Screen

The MAC filter screen allows you to configure the LTE3301 to give exclusive access to devices
(Allow) or exclude devices from accessing the LTE3301 (Deny). Every Ethernet device has a
unique MAC (Media Access Control) address. The MAC address is assigned at the factory and
consists of six pairs of hexadecimal characters, for example, 00:A0:C5:00:00:02. You need to know
the MAC address of the devices to configure this screen.
To change your LTE3301's MAC filter settings, click Network > Wireless LAN > MAC Filter. The
screen appears as shown.
Chapter 7 Wireless LAN
DESCRIPTION
Select this to activate the SSID profile.
The SSID (Service Set IDentity) identifies the Service Set with which a wireless client is
associated. Enter a descriptive name (up to 32 printable characters found on a typical
English language keyboard) for the wireless LAN.
Select this check box to hide the SSID in the outgoing beacon frame so a station cannot
obtain the SSID through scanning using a site survey tool.
A Basic Service Set (BSS) exists when all communications between wireless clients or
between a wireless client and a wired network client go through one access point (AP).
Intra-BSS traffic is traffic between wireless clients in the BSS. When Intra-BSS is enabled,
wireless clients can access the wired network and communicate with each other. When
Intra-BSS is disabled, wireless clients can still access the wired network but cannot
communicate with each other.
Check this to have the LTE3301 automatically give a service a priority level according to the
ToS value in the IP header of packets it sends.
WMM QoS (Wifi MultiMedia Quality of Service) gives high priority to voice and video, which
makes them run more smoothly.
Select Static WEP, WPA-PSK, WPA, WPA2-PSK or WPA2 to add security on this
wireless network. The wireless clients which want to associate to this network must have
same wireless security settings as this device. After you select to use a security, additional
options appears in this screen. See
different security modes. Or you can select No Security to allow any client to associate
this network without authentication.
Note: If the WPS function is enabled (default), only No Security and WPA2-PSK are
available in this field.
Click Apply to save your changes back to the LTE3301.
Click Cancel to reload the previous configuration for this screen.
LTE3301 Series User's Guide
Section 7.3 on page 66
73
for detailed information on