Table of Contents
Advertisement
4.18 RSTP Status
The following example shows three RSTP topologies operate in three VLANs configured in a switch.
___________________________________________________________________________________________________________________________________________________
RSTP Status
___________________________________________________________________________________________________________________________________________________
VLAN Id
Bridge Id
Hello Time
Max. Age
Fwd Delay
Topology
Root Id
___________________________________________________________________________________________________________________________________________________
[Refresh]
___________________________________________________________________________________________________________________________________________________
Description
The VLAN which has STP enabled ports
STP bridge ID [Priority:MAC address] detected in the associated VLAN
Hello Time is used to determine the periodic time to send normal BPDU from
designated ports among bridges. It decides how long a bridge should send this
message to other bridge to tell I am alive.
1 ~ 10 seconds
When the switch is root bridge, the whole LAN uses this setting as the maximum age
time.
6 ~ 40 seconds
This figure is set at Root Bridge only.
Steady - The STP topology is steady.
Changing - The STP topology is changing.
The MAC address of current STP root
If the switch is STP root, a message of [The switch is Root.] is displayed.
Click to refresh the status
-103-
Advertisement
Table of Contents
