Installing Logset - Montigo H38DF-ST Indoor Installation, Operation & Maintenance Manual

H38DF-ST
Installing the Logs and Embers
Bottom Logs
The H38DF-ST is supplied with eight (8) fibre logs. The two small
bottom logs ("A" ) are mounted on the burner grate by placing them
diagonally onto the supplied Log stands. The long Front / Back logs
("B") are placed against the grate as shown in Figure 36b. Note:
When placing logs, arrange Logs "B" as not to cover Burner holes.
Top Logs
Next are the logs "C" which are placed diagonally, as shown in
Figure 36c. The last Logs "D" are then mounted on top of logs "A" as
shown in Figure 36d.
WARNING: If logs are not placed properly, excessive sooting will result.
Burner holes (front & back burner),
note hole pattern when placing logs
Air Inlets
Log Stand
Front of Fireplace
Figure 36. (Empty firebox showing the Left & Right stands).
Log A
Figure 36a. (Place Logs' "A" on Left & Right stands).
Log B
Figure 36b. (Place Logs' "B" as shown, in front of Right-hand "A",
and behind Left-hand "B".
Part No. XG0207 -092109
Installation
Log Stand
Burners
Log A
Log B
H(L)38DF-ST See-thru indoor Gas Fireplace
Log C
Figure 36c. Log Installation. (Place Logs' "C" on-top of Logs "A".
Indentations on-top of Logs' "A"
Log D
Figure 36d. Completed Installation.
Installing the Ember Material
The ember material is supplied in two packages. Place the material
evenly, forward of both Log stands, under logs 'A' and 'B', also for-
ward from Logs 'C' & 'D'. Refer to figure 36b. Ensure the burner holes
are free of ember material after placing the embers.
Log C
Log D
Page 17