Table of Contents
Advertisement
H34D Gas Fireplace
Installing the Log Set
Installing the Logs:
Log 'D'
The H34DF is supplied with four ceramic fibre logs and a ceramic fibre
logset base. Unpack the logs and handle them very carefully.
Bottom Left Log
Top Left Log
Figure 28a. H34DF's five piece logset.
1.
Remove the glass door.
2.
The base log is factory-installed, as shown below in figure 28b.
Figure 28b. Base log placement.
3.
Arrange the ember chips on top of the burner tray. Care should
be taken when placing the ember chips, as blocked burner ports
may cause an incorrect flame pattern, carbon deposits and
delayed ignition. Also, the chips must never be placed in a way
that obstructs any of the air inlet ports, located at the rear of the
burner, as shown in figure 28c.
Air Inlet Ports
Ember Chips
Figure 28c. Ember Chip placement.
Page 14
Installation
Base Log
Bottom Right Log
Top Right Log
Base Log
3.
Place the bottom left and right logs as shown below in figure 28d.
4.
Place the top left and right logs as shown in figure 28e.
Bottom Left Log
Figure 28d. Bottom left and right log placement.
Top Left Log
Figure 28e. Top left and right log placement.
5.
Start the fireplace. If the flame appears satisfactory, replace the
glass door. If the flame does not appear satisfactory, double-check
the air inlet and exhaust outlet pipe to ensure that they are
unobstructed.
Cautions:
■
If logs are not placed properly, excessive sooting
will result.
■
The surface of the logs will crack due to the heat
from the flames. This is a normal occurance.
Bottom Right Log
Top Right Log
Part No. XG0130
Advertisement
Table of Contents
