Section 9: Installing The Accessories; Installing The H38C* Logset - Montigo H38DF-CLCR Installation & Maintenance Manual

Section 9: Installing the Accessories

Installing the H38C* Logset

The H38C* is supplied with eight (8) fibre logs. The two small bottom
logs ("A" ) are mounted on the burner grate by placing them diagonally
onto the supplied Log stands� The long Front / Back logs ("B") are
placed against the grate as shown in Figure 25b. Note: When placing
logs, arrange Logs "B" as not to cover Burner holes.
Next are the Top logs "C" which are placed diagonally, as shown in
Figure 25c� The last logs "D" is then mounted on top of logs "A" as
shown in Figure 25d.
Installing the Ember Material
The ember material is supplied in two packages. Spread the material
evenly around the burner tray, or pile around burner holes for a realistic
effect.
Burner holes (front & back burner),
note hole pattern when placing logs
Air Inlets
Log Stand
Front of Fireplace
Figure 25� Empty firebox showing the Left & Right stands)
Log A
Figure 25a� Place Logs' "A" on Left & Right stands.
Log B
Figure 25b. Place Logs' "B" as shown, in front of Right-hand "A",
and behind Left-hand "B".
XG0213 - 150204.2
Installation
Log Stand
Burners
Log A
Log B
Log C
Figure 25c. Log Installation. Place Logs' "C" on-top of Logs "A".
Indentations on-top of Logs' "A"
Log D
Figure 25d. Completed Installation.
NOTICE
If logs are not placed properly, excessive sooting will result.
NOTICE
Do not use ammonia based or abrasive cleaners on the glass, they will permanently
etch the surface. Use an approved gas fireplace glass cleaner such as Kel-Kem or
White off.
NOTICE
Do not operate this fireplace without the glass door or with a broken glass door.
H*38DF-CLCR Corner Gas Fireplace
Log C
Log D
Page 25