Vent Terminations - Montigo H38DF-ST Indoor Installation, Operation & Maintenance Manual

H(L)38DF-ST See-thru indoor Gas Fireplace
CAUTION!
Due to its high operating temperatures, the appliance should
be located out of traffic & away from furniture and draperies.
 Children and adults should be alerted to the hazards
of the high surface temperature, which could cause
burns or clothing ignition.
Young children should be carefully supervised when

they are in the same room as the appliance.
 Clothing or other flammable materials should not be
placed on or near the appliance.
CAUTION:
Do not obstruct, or attempt to conceal, the vent termination.

These actions will affect the operation of the fireplace, and may
be hazardous.
In heavy snow areas, take extra care to prevent snow buildup

from obstructing the vent termination.
Cautions:
Vent terminations can be very hot. If the termination is less than 7 feet

above a public walkway, it should be fitted with a certified Montigo
Heat Guard. (Part no. PTKOG).
Do not obstruct, or attempt to conceal the vent termination.

These actions will affect the operation of the fireplace, and may
be hazardous.
In heavy snow areas, take extra care to prevent snow buildup

from obstructing the vent termination.
Use Montigo Vinyl Heat Shield (Part no. VSS) when using on

applications with vinyl siding to guard against possible damage.
Installing Terminations with Built-In Frames
11
11
Figure 4a. Installing a PTO termination.
Page 6
Installation
1.
2.
Installing Terminations with MSR Frames
Figure 4b. Installing a PTO termination with the MSR frame.
1. Frame the termination opening to 12" x 12".
2. Fasten the termination to the studs using a minimum of 4 screws.
Installing Terminations with MOSR Frames
PTO-3F (5"/8")
Figure 4c. Installing a PTO termination with the MOSR frame.
1.
2. Fasten the MOSR frame to the interior side of the studs using a
3. Insert the termination into the MOSR frame as shown here, and
Installing Heat Guards over Terminations
PTO-3F (5"/8")
Figure 4d. Installing a PTO termination heat guard.
Frame the termination opening to 11" x 11".
Fasten the termination to the studs using a minimum of 4
screws.
12
12
MOSR
Frame the termination opening to 12" x 12".
minimum of 4 screws.
attach by screwing through the four pilot holes in the termination.
MSR
PTO-3F (5"/8")
12 12
12
PTKOG (5"/8")
Part No. XG0207 - 092109